Setup Craft Beer

Thank you for purchasing
“Ready to Drink Now! Premium Selection”
from Tete-Nomi.

Tonight, you are the bartender!
Set up the craft beer on the dispenser and pour your own luxurious, perfect glass.
We’ll walk you through the setup and how to pour draft beer.

1. Open the cap of the PET bottle.

2. Press and hold the locks at the top and bottom of the adapter (spout and lever), then pull it out.

3. Attach the adapter (spout and lever) to the PET bottle.
※ Once inserted into the PET bottle, turn it clockwise to attach (please be careful not to over-tighten).

4. Insert the PET bottle with the adapter attached into the dispenser.
※ You’ll hear a “click” when it’s in the correct position — align it so the lever is vertical.
※ Please avoid touching the lever, as beer may leak out.

5. Push the connector in until it clicks into place.

6. With an empty glass held under the spout, release the gas.
※ At first, only gas may come out.

That completes the setup. Now, let’s pour your first draft beer!

7. Hold the glass at a 45-degree angle to the spout and tilt the lever toward you to pour the beer.
※ Gradually tilt the glass upright as you pour, to avoid spilling.
★ If you hold the glass away from the spout, the foam will become coarse — pour along the inside of the glass for the best result.

8. The finishing touch: push the lever away from you to pour smooth, fine foam only.
Find your favorite ratio of creamy foam to beer!