How to Setup
Tap Marche
Preparation and Operation of Beer Dispensing（1:18）
STEP1: Check that the gas hose is connected to the dispenser.
STEP2: Open the main valve of the gas cylinder and set the pressure regulator gauge to 0.8.
STEP3: Open and close the cap of the Tap Marche PET bottle.
STEP4: Press the adapter lock and pull it out.
STEP5: Attach the adapter to the PET bottle.
STEP6: Check the position of the lever.
STEP7: Turn the adapter clockwise to attach it.
STEP8: Insert the PET bottle into the dispenser.
STEP9: Align the adapter until it clicks into place.
STEP10: Do not touch the lever, as beer may leak out.
STEP11: Align the adapter until it clicks into place.
STEP12: Push the connector in until it clicks.
STEP13: Gas alone may come out at first, so please release the gas.
STEP14: Tilt the lever toward you to dispense beer.
STEP15: Push the lever back to dispense foam only.
Replacing the PET Bottle（1:15）
When replacing the PET bottle, please do not touch the tap lever, as beer may leak out.
When replacing the PET bottle, wash the adapter and tap with water, and rinse the beer dispensing tube and adapter with water.